Step 1

Step 1

Before drilling, assemble rails onto ¼” pins putting nylon washers in between rails. Center davit onto the platform. Make sure to hold around 36” (minimum) from center of the davit to the back of the boat, keeping some of the foot on the platform for support.

Step 2

Step 2

Before drilling with the ¼” drill, maintain a gap (about the same as the nylon washers at the black arrows) Drill through the platform at the red arrows with the ¼” drill. We recommend using stainless bolts through the platform.

Step 3

Step 3

Lift up davit and finish drilling. Insert bolts.

Step 4

Step 4

We recommend using a marine grade silicone seal to fill holes.

FAILURE TO INSATALL, MAINTAIN, AND OPERATE THE SYSTEM PROPERLY
CAN CAUSE MALFUNCTION RESULTING IN POSSIBLE SERIOUS OR FATAL
INJURIES AND OR PROPERTY DAMAGE.
DO NOT attempt to operate system while boat is under power.
DO NOT modify, drill holes, cut or alter your davit system in any way.
DO NOT install system where it can come into contact with prop, outdrive or any other mechanical part .
DO NOT attempt to use the davit system with any person(s) and or possessions in the dinghy
ALWAYS remove drain plug from dinghy when on the davit system.
ALWAYS use stainless steel hardware when mounting and use backing plates when applicable.
ALWAYS tie down dinghy securely before transporting.
ALWAYS contact your manufacturer to ensure that your swim platform can handle the extra added weight.
ALWAYS clean the davit system with fresh water when it is used in a corrosive environment.
ALWAYS inspect, maintain your davit system to ensure proper operation.
WEIGHT LIMIT do not exceed the 325 pound load limit.

TJ Marine Enterprises, Inc.